Behringer Hellbabae question
I just got one...new. I know it's generally not considered a great
pedal. but I needed one quick for one song I'm recording..so $29 made
sense.. and it sounds pretty good once tweaked...BUT. When I shut off
the wah (or I should say when it shuts itself off automatically)It
does not seem to go into any by-pass mode. It just turns off all
sound. I tried both the by-pass output as well as the regular output
output. Works fine with wah...no sound through amp when wah is off. Am
I missing something obvious..or is this a defect in the pedal (I know
there are generally a lot of defects in these pedals)?
on the underside of the pedal. close to the battery holder. you'll find
a slot. This slot is labelled Bypass Timer Adjuster - and it allows you
to set a trim potentiometer (you'll need a small flat screrwdriver for
this). Have you tried adjusting this setting ?
If this doesn't help. then perhaps you'd let us know wherebaouts you
are located so that we can initiate warranty service procedures.
Guitar Lesson
|
Return to Main Page
Comments
|